The stopcock is not open.
Terminate the wash programme.
Open the stopcock.
Select the programme and start it again.
Podrška za vaš
Washer Dryer
Check inlet indicator light flashes
The Check inlet indicator light on the washing machine/washer-dryer flashes. The water inlet is blocked or restricted.
The inlet filter is soiled.
Sample illustrations
Clean the inlet filter:
First turn off the stopcock.
Unscrew the water inlet hose from the stopcock.
Remove the rubber seal (1) from the recess.
Hold the free end of the water inlet hose upside down.
The plastic filter (2) will fall out.
Clean the water inlet filter.
The water inlet filter must be put back in place after cleaning.
Reassemble in reverse order.
Turn on the stopcock and check that the connection is watertight.
If water drips out, tighten the connection.
Additional information can be found in the linked video.
The water inlet hose is kinked.
Remove any kinks or loops from the water inlet hose.
Keep an eye on these points for a while afterwards, as the plastic may weaken and tear. In the event of any damage, the water inlet hose must be replaced. Please contact Miele Customer Service.
The water connection pressure in the water supply pipe is too low.
With the stopcock fully open, at least 5 l of water should flow from it within 15 s.
Contact the facility manager or a plumber.
The water connection pressure in the water supply pipe is too low and cannot be increased.
Contact Miele Customer Service.
Dodatni sadržaji
Pretraživač uputstava za upotrebu
Ovde ćete pronaći uputstva za upotrebu za svoje Miele uređaje
Pronađite svoje uputstvo
Rezervišite tehničara
Rado ćemo primiti vašu rezervaciju za popravku putem interneta ili telefonom
Planirajte posetu
Kontaktirajte nas
Posetite našu stranicu Kontaktirajte nas da vidite različite načine na koje možete razgovarati s nama.
Kontaktirajte nas